Author: G. S. RootPublisher:
ISBN:
Category : Titanium alloys
Languages : en
Pages : 16
Book Description
The Effect of Rate of Heating to Aging Temperature on the Tensile Properties of Ti-2.5Al-16V Alloy Sheet
Author: G. S. RootPublisher:
ISBN:
Category : Titanium alloys
Languages : en
Pages : 16
Book Description
Statistical Analysis of Tensile Properties of Heat-treated Ti-4A1-3Mo-1V and Ti-2.5A1-16V Sheet
Author: G. H BeattyPublisher:
ISBN:
Category : Metals
Languages : en
Pages : 54
Book Description
IN THE SOLUTION TREATED AND AGED CONDITION, Ti4Al-3Mo-1V has a higher ultimate strength than does Ti-2.5Al-16V, but the two alloys are about even in yield strength and elongation. In the solution-treated condition, Ti-4Al-3Mo-1V is unquestionably stronger than Ti-2.5Al-16V. These conclusions are independent of producer. There is not much difference in the same alloy produced by different companies. The alloys developed under the Titanium-Alloy Sheet-Rolling Program would not endure the most critical interpretation of release property specifications. On the other hand, these alloys come reasonably close to specifications. A complete set of release property specifications is available only for specimens that have been solution treated and aged. Such specimens do not all exhibit the desired ultimate and yield strength, but the percentage of rejects is small enough to be encouraging. (Author).
Statistical Analysis of Tensile Properties of Heat-treated Ti-4A1-3Mo-1V Sheet
Author: H. R. OgdenThe Effect of Artificial Aging on the Tensile Properties of Alclad 24S-T and 24S-T Aluminum Alloy
Author: Joseph N. KotanchikPublisher:
ISBN:
Category : Aerodynamics
Languages : en
Pages : 32
Book Description
Summary: An experimental study was made to determine the effect of artificial aging on the tensile properties of alclad 24S-T and 24S-T aluminum-alloy sheet material. The results of the tests show that certain combinations of aging time and temperature cause a marked increase in the yield strength and a small increase in the ultimate strength; these increases are accompanied by a very large decrease in elongation. A curve is presented that shows the maximum yield strengths that can be obtained by aging this material at various combinations of time and temperature. The higher values of yield stress are obtained in material aged at relatively longer times and lower temperatures.
Effects of Moderately High Strain Rates on the Tensile Properties of Metals
Author: D. P. MoonSelected Short-time Tensile and Creep Data Obtained Under Conditions of Rapid Hearting
Author: Donald P. MoonPublisher:
ISBN:
Category : Aerodynamic heating
Languages : en
Pages : 102
Book Description
Smooth and Sharpe-notch Property Variations for Several Heats of Ti-6A1-4V Sheet at Room and Cryogenic Temperatures
Author: Morgan P. HansonPublisher:
ISBN:
Category : Statistical matching
Languages : en
Pages : 22
Book Description
Properties of Mar-aging Steels
Author: D. C. DrennenPublisher:
ISBN:
Category : Maraging steel
Languages : en
Pages : 60
Book Description
A Bibliography on Effect of Temperature on Properties of Metals
Author: American Society of Mechanical EngineersPublisher:
ISBN:
Category : Metals
Languages : en
Pages : 36
Book Description
Symposium on Effect of Temperature on the Properties of Metals
Author: American Society of Mechanical EngineersPublisher: ASTM International
ISBN:
Category : Metals
Languages : en
Pages : 830
Book Description