Author: Tom SussenbachPublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 10
Book Description
Phase One Archaeological Survey of the Norris Thomas Slide, AML Reclamation Project, Carter County, Kentucky
Author: Tom SussenbachPublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 10
Book Description
Phase One Archaeological Survey of the Hances Ridge Slides Abandoned Mine Lands Reclamation Project, Bell County, Kentucky
Author: John CarterPublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 24
Book Description
An Archaeological Survey of the Beattyville and Heidelberg Tipples and Barge Load Facilities
Author: Rose G. MoorePublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 74
Book Description
An Archaeological Survey of the Proposed Wayne Sapp Landslide AML Reclamation Project in Knott and Perry Counties, Kentucky
Author: Rose G. MoorePublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 20
Book Description
Phase One Archaeological Survey for the U.S. 60-Rock Crusher Curve Project (Item No. 9-159.00), Carter County, Kentucky
Author: Michael StrikerPublisher:
ISBN:
Category : Archaeological surveying
Languages : en
Pages : 108
Book Description
The Story of Detroit
Author: George Byron CatlinPublisher:
ISBN:
Category : Detroit (Mich.)
Languages : en
Pages : 792
Book Description
Tool and Cutter Grinding
Author: Marcus BowmanPublisher: The Crowood Press
ISBN: 1785008617
Category : Technology & Engineering
Languages : en
Pages : 612
Book Description
The cutting edges on engineering tools must lie at precise angles to ensure effective cutting, and sharpening must recreate the original geometry of each tool. This book provides an understanding of what is involved in sharpening typical lathe, milling, drilling and threading tools. With over 550 photographs and illustrations this new book covers sharpening techniques for the most commonly used engineering tools, screwdrivers and gravers, lathe, milling, reaming, drilling and threading cutters. It identifies the two principal types of workhead, and discusses the ways in which their geometry affects typical sharpening setups. It teaches how to use the three basic movements of swing, tilt and rotate to position a tool against a grinding wheel to ensure correct tool angles and sharp cutting edges. Contains useful tables for setting cutting and clearance angles and provides general advice on tool and cutter grinders, and includes examples of the use of workholders to suit a range of tools. Includes information on abrasive materials and the types and shapes of grinding wheel suitable for use on a tool and cutter grinder. Finally, it shows photos of accessories that can be made to simplify setups, including workheads, toolholders and fixtures used to hold circular saws, parting tools and dies, as well as an angle gauge to quickly set clearance angles on reamers and milling cutters.
Introduction to Potential Fields
Author: Roads Were Not Built for Cars
Author: Carlton ReidPublisher: Island Press
ISBN: 1610916891
Category : Architecture
Languages : en
Pages : 374
Book Description
In Roads Were Not Built for Cars, Carlton Reid reveals the pivotal—and largely unrecognized—role that bicyclists played in the development of modern roadways. Reid introduces readers to cycling personalities, such as Henry Ford, and the cycling advocacy groups that influenced early road improvements, literally paving the way for the motor car. When the bicycle morphed from the vehicle of rich transport progressives in the 1890s to the “poor man’s transport” in the 1920s, some cyclists became ardent motorists and were all too happy to forget their cycling roots. But, Reid explains, many motor pioneers continued cycling, celebrating the shared links between transport modes that are now seen as worlds apart. In this engaging and meticulously researched book, Carlton Reid encourages us all to celebrate those links once again.
Author: