Author: Hugh Won ChanPublisher:
ISBN:
Category : Heat
Languages : en
Pages : 112
Book Description
The Effect of Air Injection on the Heat Transfer from a Flat Plate
Author: Hugh Won ChanEffect of Local Normal Injection on Flat Plate Heat Transfer
Author: Steve ScesaHeat Transfer from a Flat Plate with Tangential Air Injection
Author: John Herbert PittsPublisher:
ISBN:
Category : Boundary layer
Languages : en
Pages : 80
Book Description
NASA Technical Note
Author: A Preliminary Investigation of the Effect of Accelerated Air Flow on the Heat Transfer of a Flat Plate
Author: Eugene BehunThe Relation Between Skin Friction and Heat Transfer for the Compressible Turbulent Boundary Layer with Gas Injection
Author: C. C. PappasPublisher:
ISBN:
Category : Air flow
Languages : en
Pages : 34
Book Description
Heat, Mass, and Momentum Transfer for Flow Over a Flat Plate with Blowing Or Suction
Author: H. S. MickleyPublisher:
ISBN:
Category : Air flow
Languages : en
Pages : 166
Book Description
The effect on the boundary layer of sucking or blowing air through a porous flat plate into or out of a main air stream flowing parallel to the plate was studied theoretically and experimentally.
The Effect of Fluid Injection on the Compressible Turbulent Boundary Layer
Author: Morris W. RubesinPublisher:
ISBN:
Category : Air flow
Languages : en
Pages : 37
Book Description
Local values of heat-transfer rate and temperature-recovery factor, obtained on a transpiration-cooled flat plate, are presented. Air was injected into a turbulent boundary layer at several rates of flow through a porous flat plate oriented parallel to an air stream. Surface temperatures were maintained near recovery temperature. The Mach number was 2.7 and the Reynolds number range was 1,500,000 to 7,000,000. The results for nearly uniform injection show: (1) The ratio of local Stanton number with injection to that with zero injection decreases appreciably with increased injection rate and this decrease is greater at the higher Reynolds numbers. The decrease is comparable to the predicted theoretical values. (2) The local temperature-recovery factor decreases with increasing injection rate at a given Reynolds number and the rate of decrease is greater at the higher Reynolds numbers. These effects are not predicted by the theory. (3) The transpiration cooling process requires considerably less coolant than conventional heat exchangers to maintain a given cooled surface temperature, especially for high cooling loads.
A Review of High-speed, Convective, Heat-transfer Computation Methods
Author: Michael E. TauberPublisher:
ISBN:
Category : Aerodynamic heating
Languages : en
Pages : 44
Book Description
Proceedings Of The International Heat Transfer Conference
Author: LeePublisher: CRC Press
ISBN: 9781560327974
Category : Science
Languages : en
Pages : 696
Book Description
This year's set of papers includes 23 Keynote Papers and 537 refereed General Papers, in seven volumes. Experts from around the world have combined to address the leading edge of research and practical innovations in convection, combustion, heat exchangers, two-phase flow, and much more. Whether one is involved in mechanical, chemical, nuclear, or energy engineering the quantity, international scope, and high quality of the contents make access to these volumes essential.