Author: Harold SadwickPublisher:
ISBN:
Category :
Languages : en
Pages : 34
Book Description
The Development of a High-temperature Laboratory Furnace
Author: Harold SadwickHigh Temperature Laboratory Furnaces
Author: D. R. WilderPublisher:
ISBN:
Category : Furnaces
Languages : en
Pages : 28
Book Description
Materials Support for the Development of a High Temperature Advanced Furnace
Author: Development of High-temperature Strain Gages
Author: J. W. PittsPublisher:
ISBN:
Category : Cement
Languages : en
Pages : 322
Book Description
A summary is presented of a research program aimed at the improvement of high-temperature strain gages of the electrical resistance type. Potential ceramic and metal components were evaluated and a gage was devised that was based on these evaluations. This gage (NBS 5B) was flexible and easy to install; however, it lacked resistance stability at higher temperatures. In an attempt to minimize this deficiency, ceramic cements were developed that showed greater electrical resistivity than had been previously observed in the range 800 to 1800 degrees Fahrenheit; also, a technique was devised for increasing the resistance to ground by applying a fired-on ceramic coating to the grid of a specifically developed unbacked gage. A study was made of the cause of the erratic response of cemented gages that had not been preheated prior to use. There were strong indications that the erratic response was caused mostly by the rapid decrease in resistance that accompanied structural changes in the cement.
High Temperature Air Combustion
Author: Hiroshi TsujiPublisher: CRC Press
ISBN: 1420041037
Category : Nature
Languages : en
Pages : 425
Book Description
Maximize efficiency and minimize pollution: the breakthrough technology of high temperature air combustion (HiTAC) holds the potential to overcome the limitations of conventional combustion and allow engineers to finally meet this long-standing imperative. Research has shown that HiTAC technology can provide simultaneous reduction of CO2 and nitric
The Development of the High Temperature Structures Research Laboratory at Purdue University
Author: R. J. H. BollardPublisher:
ISBN:
Category : High temperatures
Languages : en
Pages : 72
Book Description
A SMALL HIGH TEMPERATURE LABORATORY FURNACE.
Author: Transactions of the Faraday Society
Author: Faraday SocietyPublisher:
ISBN:
Category : Chemistry
Languages : en
Pages : 398
Book Description
Development and Operation of a High Temperature Quenching Furnace
Author: Eyerly George B.Publisher:
ISBN:
Category : Furnaces
Languages : en
Pages : 34
Book Description
The development and construction of a vacuum quenching furnace for operation at temperatures up to 2800 degrees C is described. In operation this furnace can be heated to this temperature in a period of one hour. Heated samples can be quenched from one to three seconds, and the furnace can be cooled sufficiently to permit the removal of the specimens in thirty minutes.
Development of a High Temperature Gas-fired Vacuum Furnace for General Heat Treating
Author: K. H. HemsathPublisher:
ISBN:
Category : Furnaces
Languages : en
Pages : 148
Book Description