Author: Liang Yun
Publisher: Springer Science & Business Media
ISBN: 144190042X
Category : Technology & Engineering
Languages : en
Pages : 459
Book Description
In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.
WIG Craft and Ekranoplan
Author: Liang Yun
Publisher: Springer Science & Business Media
ISBN: 144190042X
Category : Technology & Engineering
Languages : en
Pages : 459
Book Description
In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.
Publisher: Springer Science & Business Media
ISBN: 144190042X
Category : Technology & Engineering
Languages : en
Pages : 459
Book Description
In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.
Aerodynamics of a Lifting System in Extreme Ground Effect
Author: Kirill V. Rozhdestvensky
Publisher: Springer Science & Business Media
ISBN: 3662042401
Category : Technology & Engineering
Languages : en
Pages : 358
Book Description
This book is dedicated to the memory of a distinguished Russian engineer, Rostislav E. Alexeyev, who was the first in the world to develop the largest ground effect machine - Ekranoplan. One of Alexeyev's design concepts with the aerodynamic configuration of a jlying wing can be seen on the front page. The book presents a description of a mathematical model of flow past a lifting system, performing steady and unsteady motions in close proximity to the underlying solid surface (ground). This case is interesting for practical purposes because both the aerodynamic and the economic efficiency of the system near the ground are most pronounced. Use of the method of matched asymptotic expansions enables closed form solutions for the aerodynamic characteristics of the wings-in-ground effect. These can be used for design, identification, and processing of experimental data in the course of developing ground effect vehicles. The term extreme ground effect, widely used through out the book, is associated with very small relative ground clearances of the order of 10% or less. The theory of a lifting surface, moving in immediate proximity to the ground, represents one of the few limiting cases that can be treated analytically. The author would like to acknowledge that this work has been influenced by the ideas of Professor Sheila E. Widnall, who was the first to apply the matched asymptotics techniques to treat lifting flows with the ground effect. Saint Petersburg, Russia February 2000 Kirill V. Rozhdestvensky Contents 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Publisher: Springer Science & Business Media
ISBN: 3662042401
Category : Technology & Engineering
Languages : en
Pages : 358
Book Description
This book is dedicated to the memory of a distinguished Russian engineer, Rostislav E. Alexeyev, who was the first in the world to develop the largest ground effect machine - Ekranoplan. One of Alexeyev's design concepts with the aerodynamic configuration of a jlying wing can be seen on the front page. The book presents a description of a mathematical model of flow past a lifting system, performing steady and unsteady motions in close proximity to the underlying solid surface (ground). This case is interesting for practical purposes because both the aerodynamic and the economic efficiency of the system near the ground are most pronounced. Use of the method of matched asymptotic expansions enables closed form solutions for the aerodynamic characteristics of the wings-in-ground effect. These can be used for design, identification, and processing of experimental data in the course of developing ground effect vehicles. The term extreme ground effect, widely used through out the book, is associated with very small relative ground clearances of the order of 10% or less. The theory of a lifting surface, moving in immediate proximity to the ground, represents one of the few limiting cases that can be treated analytically. The author would like to acknowledge that this work has been influenced by the ideas of Professor Sheila E. Widnall, who was the first to apply the matched asymptotics techniques to treat lifting flows with the ground effect. Saint Petersburg, Russia February 2000 Kirill V. Rozhdestvensky Contents 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Research on New Transportation Methods (ground Effect Machinges).
Author: United States. Congress. House. Committee on Science and Astronautics
Publisher:
ISBN:
Category : Ground-effect machines
Languages : en
Pages : 92
Book Description
Publisher:
ISBN:
Category : Ground-effect machines
Languages : en
Pages : 92
Book Description
Theory and Design of Air Cushion Craft
Author: Liang Yun
Publisher: Elsevier
ISBN: 0080519067
Category : Technology & Engineering
Languages : en
Pages : 647
Book Description
This definitive text describes the theory and design both of Air Cushion Vehicles (ACV) and Surface Effect Ships (SES). It begins by introducing hovercraft types and their development and application throughout the world in the last three decades, before going on to discuss the theoretical aspects of ACV and SES craft covering their hovering performance, dynamic trim over calm water, resistance, stability, manoeuvrability, skirt configuration and analysis of forces acting on the skirts, ACV and SES seakeeping, and the methodology of scaling aerodynamic and hydrodynamic forces acting on the ACV/SES from model test data. The latter chapters describe a design methodology, including design criteria and standard methods for estimating craft performance, lift system design, skirt design, hull structure, propulsion systems and power unit selection. Much technical information, data, and references to further work on hovercraft and SES design is provided. The book will be a useful reference to engineers, technicians, teachers, students (both undergraduate and postgraduate), operators etc. who are involved in ACV/SES research, design, construction and operation. - Guides the reader on how to perform machinery and systems selection within ACV and SES overall design - For teachers, students (both at under- and post-graduate level), engineers and technicians involved in ACV/SES
Publisher: Elsevier
ISBN: 0080519067
Category : Technology & Engineering
Languages : en
Pages : 647
Book Description
This definitive text describes the theory and design both of Air Cushion Vehicles (ACV) and Surface Effect Ships (SES). It begins by introducing hovercraft types and their development and application throughout the world in the last three decades, before going on to discuss the theoretical aspects of ACV and SES craft covering their hovering performance, dynamic trim over calm water, resistance, stability, manoeuvrability, skirt configuration and analysis of forces acting on the skirts, ACV and SES seakeeping, and the methodology of scaling aerodynamic and hydrodynamic forces acting on the ACV/SES from model test data. The latter chapters describe a design methodology, including design criteria and standard methods for estimating craft performance, lift system design, skirt design, hull structure, propulsion systems and power unit selection. Much technical information, data, and references to further work on hovercraft and SES design is provided. The book will be a useful reference to engineers, technicians, teachers, students (both undergraduate and postgraduate), operators etc. who are involved in ACV/SES research, design, construction and operation. - Guides the reader on how to perform machinery and systems selection within ACV and SES overall design - For teachers, students (both at under- and post-graduate level), engineers and technicians involved in ACV/SES
Lotus 78 and 79
Author: John Tipler
Publisher: Crowood Press UK
ISBN: 9781847971432
Category : Sports & Recreation
Languages : en
Pages : 0
Book Description
New in paperback, this is a book for fans of the golden era of Formula 1. Aimed at motor historians and enthusiasts, this is the first, and the last, word on these fabulous 'ground effect' racing cars. Superbly illustrated with 170 black & white photographs, 20 color photographs and the original working drawings and the cutaways of Tony Matthews. John Tipler is a freelance motoring writer and historian with numerous books on motorsport topics to his credit.
Publisher: Crowood Press UK
ISBN: 9781847971432
Category : Sports & Recreation
Languages : en
Pages : 0
Book Description
New in paperback, this is a book for fans of the golden era of Formula 1. Aimed at motor historians and enthusiasts, this is the first, and the last, word on these fabulous 'ground effect' racing cars. Superbly illustrated with 170 black & white photographs, 20 color photographs and the original working drawings and the cutaways of Tony Matthews. John Tipler is a freelance motoring writer and historian with numerous books on motorsport topics to his credit.
NASA Thesaurus
The Code of Federal Regulations of the United States of America
Author:
Publisher:
ISBN:
Category : Administrative law
Languages : en
Pages : 808
Book Description
The Code of Federal Regulations is the codification of the general and permanent rules published in the Federal Register by the executive departments and agencies of the Federal Government.
Publisher:
ISBN:
Category : Administrative law
Languages : en
Pages : 808
Book Description
The Code of Federal Regulations is the codification of the general and permanent rules published in the Federal Register by the executive departments and agencies of the Federal Government.
DTNSRDC.
Author: David W. Taylor Naval Ship Research and Development Center
Publisher:
ISBN:
Category : Shipbuilding
Languages : en
Pages : 540
Book Description
Publisher:
ISBN:
Category : Shipbuilding
Languages : en
Pages : 540
Book Description
Code of Federal Regulations
Export Administration Regulations
Author: United States. Bureau of Export Administration
Publisher:
ISBN:
Category : Export controls
Languages : en
Pages : 866
Book Description
Publisher:
ISBN:
Category : Export controls
Languages : en
Pages : 866
Book Description