Preliminary Evaluation of Radiation Control Coatings for Energy Conservation in Buildings PDF Download

Author: R. W. Anderson
Publisher:
ISBN:
Category : Buildings
Languages : en
Pages : 27

View

Book Description

Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 27

View

Book Description
Radiation Control Coatings (RCCs) applied to external building surfaces can reflect about 85 percent of the solar heating from the surfaces of buildings. Since in warm climates, solar heating is the primary source of heat gain through walls and roofs, RCC technology represents an alternative or adjunct to conventional thermal control methods (e.g., thermal insulation) for opaque building components. The primary objectives of this project were to: (1) obtain solar and infrared reflectance data for representative RCC products, (2) evaluate test methods for measurement of the radiative properties of RCCs, (3) calculate the changes in heat flow attributed to RCCs in flat roof applications in several geographic locations, and (4) compare field tests and calculated thermal performance of an RCC in a flat roof configuration. Data are presented for the radiative properties of five commercially available RCC products as determined by several test methods. The potential energy benefits of RCCs are presented for flat roofs in both warm and cold climates.

Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 61

View

Book Description
The US Department of Energy's (DOE's) Federal Energy Management Program (FEMP) supports efforts to reduce energy use and associated expenses in the federal sector. One such effort, the New Technology Demonstration Program (NTDP), seeks to evaluate new energy-saving US technologies and secure their more timely adoption by the US government. Through a partnership with a federal site, the utility serving the site, a manufacturer of an energy-related technology, and other organizations associated with these interests, DOE can evaluate a new technology. The results of the program give federal agency decision makers more hands-on information with which to validate a decision to utilize a new technology in their facilities. The partnership of these interests is secured through a cooperative research and development agreement (CRADA), in this case between Lockheed Martin Energy Research Corporation, the manager of the Oak Ridge National Laboratory (ORNL), Oak Ridge, Tennessee, and ThermShield International, Ltd., the manufacturer of the technology. This is the first volume of a two-volume report that describes the effects of radiation control coatings installed on federal buildings at Tyndall Air Force Base (AFB) in Florida by ThermShield International. ORNL's Buildings Technology Center (BTC) was assigned the responsibility for gathering, analyzing, and reporting on the data to describe the effects of the coatings. This volume describes the monitoring plan and its implementation, the results of pre-coating monitoring, the coating installation, results from fresh coatings compared to pre-coating results, and a plan to decommission the monitoring equipment. By including results from roofs at Tyndall AFB and from an outdoor test facility at the BTC, the data cover the range from poorly insulated to well-insulated roofs and two kinds of radiation control coatings on various roof membranes.

Author: RW. Anderson
Publisher:
ISBN:
Category : Building cooling loads
Languages : en
Pages : 17

View

Book Description
Radiation Control Coatings (RCCs) applied to external building surfaces can reflect about 85 percent of the solar heating from the surfaces of buildings. Since in warm climates, solar heating is the primary source of heat gain through walls and roofs, RCC technology represents an alternative or adjunct to conventional thermal control methods (e.g. thermal insulation) for opaque building components.

Author: Thomas W. Petrie
Publisher:
ISBN:
Category :
Languages : en
Pages : 47

View

Book Description
The US Department of Energy's (DOE's) Federal Energy Management Program (FEMP) supports efforts to reduce energy use and associated expenses in the federal sector. One such effort, the New Technology Demonstration Program (NTDP), seeks to evaluate new energy-saving US technologies and secure their more timely adoption by the US government. Through a partnership with a federal site, the utility serving the site, a manufacturer of an energy-related technology, and other organizations associated with these interests, DOE can evaluate a new technology. The results of the program give federal agency decision makers more hands-on information with which to validate a decision to utilize a new technology in their facilities. This is the second volume of a two-volume report that describes the effects of radiation control coatings installed on federal buildings at Tyndall Air Force Base (AFB) in Florida by ThermShield International. ORNL's Buildings Technology Center (BTC) was assigned the responsibility for gathering, analyzing, and reporting on the data to describe the effects of the coatings. The first volume described the monitoring plan and its implementation, the results of pre-coating monitoring, the coating installation, results from fresh coatings compared to pre-coating results, and a plan to decommission the monitoring equipment. This second volume updates and completes the presentation of data to compare performance of fresh coatings with weathered coatings.

Author: Thomas W. Petrie
Publisher:
ISBN:
Category :
Languages : en
Pages : 47

View

Book Description
The US Department of Energy's (DOE's) Federal Energy Management Program (FEMP) supports efforts to reduce energy use and associated expenses in the federal sector. One such effort, the New Technology Demonstration Program (NTDP), seeks to evaluate new energy-saving US technologies and secure their more timely adoption by the US government. Through a partnership with a federal site, the utility serving the site, a manufacturer of an energy-related technology, and other organizations associated with these interests, DOE can evaluate a new technology. The results of the program give federal agency decision makers more hands-on information with which to validate a decision to utilize a new technology in their facilities. This is the second volume of a two-volume report that describes the effects of radiation control coatings installed on federal buildings at Tyndall Air Force Base (AFB) in Florida by ThermShield International. ORNL's Buildings Technology Center (BTC) was assigned the responsibility for gathering, analyzing, and reporting on the data to describe the effects of the coatings. The first volume described the monitoring plan and its implementation, the results of pre-coating monitoring, the coating installation, results from fresh coatings compared to pre-coating results, and a plan to decommission the monitoring equipment. This second volume updates and completes the presentation of data to compare performance of fresh coatings with weathered coatings.

Author:
Publisher:
ISBN:
Category : Power resources
Languages : en
Pages : 754

View

Book Description

Author:
Publisher:
ISBN:
Category : Administrative law
Languages : en
Pages : 1004

View

Book Description

Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 31

View

Book Description
The authors have tracked the solar reflectance and thermal performance of small samples of various radiation control coatings on smooth surfaces for several years on a roof test facility in East Tennessee. The focus is on white coatings because of their potential to weather, causing the solar reflectance to decrease as the coatings age. Support of the federal New Technology Demonstration Program allowed them to extend the study to more samples on smooth surfaces and entire rough-surfaced roofs at a federal facility in the Panhandle of Florida. Two rough-surfaced, moderately well-insulated, low solar reflectance built-up roofs (BURs) were spray-coated with a latex-based product with ceramic beads added to improve solar reflectance. In the first three months after installation, the fresh BUR coatings showed a significant decrease in both the outside-surface temperature and the heat flux through the roof insulation. Average sunlit values were generated to exclude nighttime data, data on cloudy days, and data when the uncoated patch on one roof was more strongly shaded in mid-afternoon on sunny days. The average power demand during occupied periods for the first month with the coating for the building with the thermally massive roof deck was 13% less than during the previous month without the coating. For the other buildings with a lightweight roof deck but high internal loads, there were no clear average power savings due to the coating. The authors are continuing to monitor electricity use in these all-electric buildings to calibrate a model for the peak power and annual energy use of the buildings. Modeling results to be given at the end of the two year project will address the effect of roof R-value, geographic location, and solar reflectance, including the effect of weathering, on the performance of coated roofs. The calibrated models should allow one to segregate site-specific effects such as shading and large thermal mass.

Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 34

View

Book Description
The technical objectives of this CRADA comprise technology deployment and energy conservation efforts with the radiation control coatings industry and the utility sector. The results of this collaboration include a high-level data reporting, analysis and management system to support the deployment efforts. The technical objectives include successfully install, commission, operate, maintain and document the performance of radiation control coatings on roofs at Tyndall AFB and the Buildings Technology Center at the Oak Ridge National Laboratory; determine the life cycle savings that can be achieved by using radiation control coatings on entire roofs at Tyndall AFB, based on documented installed cost and operating maintenance costs with and without the coatings; determine if any specific improvements are required in the coatings before they can be successfully deployed in the federal sector; determine the most effective way to facilitate the widespread and rapid deployment of radiation control coatings in the federal sector; and clearly define any barriers to deployment.