Author: Otto F. Trout
Publisher:
ISBN:
Category : Wind tunnels
Languages : en
Pages : 40
Book Description
Design Operation and Testing Capabilities of the Langley 11-inch Ceramic-heated Tunnel
Author: Otto F. Trout
Publisher:
ISBN:
Category : Wind tunnels
Languages : en
Pages : 40
Book Description
Publisher:
ISBN:
Category : Wind tunnels
Languages : en
Pages : 40
Book Description
NASA Technical Note
Keywords Index to U.S. Government Technical Reports
Author:
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 88
Book Description
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 88
Book Description
Keywords Index to U.S. Government Technical Reports (permuted Title Index).
Author: United States. Department of Commerce. Office of Technical Services
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 618
Book Description
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 618
Book Description
Evaluation of Selected Refractory Oxide Materials for Use in High-temperature Pebble-bed Wind-tunnel Heat Exchangers
Author: John D. Buckley
Publisher:
ISBN:
Category : Heat exchangers
Languages : en
Pages : 40
Book Description
Publisher:
ISBN:
Category : Heat exchangers
Languages : en
Pages : 40
Book Description
Proceedings of the OAR Research Applications Conference
A Theoretical and Experimental Investigation of the Oxidation of Molybdenum at Temperatures at which Its Trioxide is Volatile
Author: David R. Schryer
Publisher:
ISBN:
Category : Molybdenum
Languages : en
Pages : 52
Book Description
A theoretical and experimental investigation of the oxidation of molybdenum to molybdenum trioxide at temperatures at which the trioxide is volatile has been carried out. A rate equation has been derived which includes the effects of mass-transfer parameters as well chemical parameters and is applicable to any situation for which a mass-transfer coefficient can be obtained. The derived equation has been applied to previously reported rate data taken under laboratory conditions using air and oxygen-helium mix-reported rate data taken under laboratory conditions using air and oxygen-helium mixtures flowing at low subsonic velocities, and a set of values for the activation energy of the oxidation of molybdenum has been obtained. The average of these values is 8.51 x 107 J-(kg-mole)−1 (20.3 kcal-(g-mole)−1) with a standard deviation of 2.1 percent. In addition, 32 molybdenum hemisphere-cylinder specimens have been oxidized in a Mach 2.1 heated airstream at a free-stream stagnation pressure of 1.07 x 106 N-m-−2 (10.5 atm) and free-stream stagnation temperatures from 1765°K to 2120°K. The stagnation-point surface temperature and recession rate were determined for each of the specimens. The observed recession rates were compared with the corresponding values predicted theoretically by the derived rate equation and agreement within a factor of about 2 was obtained for most specimens. However, a few specimens ignited, exhibiting recession rates much greater than those predicted theoretically. The high recession rates associated with ignition were found to be the result of a sharp rise in surface temperature which caused some melting of the specimens in addition to their normal oxidation.
Publisher:
ISBN:
Category : Molybdenum
Languages : en
Pages : 52
Book Description
A theoretical and experimental investigation of the oxidation of molybdenum to molybdenum trioxide at temperatures at which the trioxide is volatile has been carried out. A rate equation has been derived which includes the effects of mass-transfer parameters as well chemical parameters and is applicable to any situation for which a mass-transfer coefficient can be obtained. The derived equation has been applied to previously reported rate data taken under laboratory conditions using air and oxygen-helium mix-reported rate data taken under laboratory conditions using air and oxygen-helium mixtures flowing at low subsonic velocities, and a set of values for the activation energy of the oxidation of molybdenum has been obtained. The average of these values is 8.51 x 107 J-(kg-mole)−1 (20.3 kcal-(g-mole)−1) with a standard deviation of 2.1 percent. In addition, 32 molybdenum hemisphere-cylinder specimens have been oxidized in a Mach 2.1 heated airstream at a free-stream stagnation pressure of 1.07 x 106 N-m-−2 (10.5 atm) and free-stream stagnation temperatures from 1765°K to 2120°K. The stagnation-point surface temperature and recession rate were determined for each of the specimens. The observed recession rates were compared with the corresponding values predicted theoretically by the derived rate equation and agreement within a factor of about 2 was obtained for most specimens. However, a few specimens ignited, exhibiting recession rates much greater than those predicted theoretically. The high recession rates associated with ignition were found to be the result of a sharp rise in surface temperature which caused some melting of the specimens in addition to their normal oxidation.