Author: Alison Carleton
Publisher:
ISBN:
Category : Parametric devices
Languages : en
Pages : 332
Book Description
Continuous-wave, Intracavity Singly-resonant Optical Parametric Oscillators Based Upon Nd-doped Laser Gain Media
Author: Alison Carleton
Publisher:
ISBN:
Category : Parametric devices
Languages : en
Pages : 332
Book Description
Publisher:
ISBN:
Category : Parametric devices
Languages : en
Pages : 332
Book Description
Continuous Wave Singly Resonant Intracavity Optical Parametric Oscillators Using Periodically Poled LiNbO3
Author: Leonel Pastor Gonzalez
Publisher:
ISBN:
Category : Continuous wave radar
Languages : en
Pages : 0
Book Description
The use of continuous wave singly resonant optical parametric oscillators (CW SROs) has been limited in the past mainly because of the high threshold powers necessary. Thresholds of SROs are orders of magnitude greater than doubly resonant oscillators. While lithium niobate has long been in use as a nonlinear material, periodically poled lithium niobate (PPLN) recently emerged as an excellent source for CW SROs. Quasi-phase matching with PPLN has allowed access to the higher nonlinear coefficients of lithium niobate permitting construction of CW SROs. By placing the OPO within the laser resonator, threshold should be significantly reduced. We have designed, built, and investigated an optical parametric oscillator within a laser cavity to access the high circulating fields within the resonator. The intracavity OPO acted as the output coupler for the laser and ideally the total down converted power from the OPO should approach the maximum output power available from th pump laser under optimal output coupling. PPLN OPOs were built within the resonators of a lamp-pumped Nd:YAG laser and a diode-pumped Nd:YVO4 laser. Combined idler output at 3.3 microns from both ends of an intracavity 30-mm PPLN OPO was 1.15 W. Output of the Nd:YVO4 laser optimized for 1.064-micron output with the same resonator was 5 W. The entire device, except for power supply and cooler, fit on a 1' x 2' breadboard.
Publisher:
ISBN:
Category : Continuous wave radar
Languages : en
Pages : 0
Book Description
The use of continuous wave singly resonant optical parametric oscillators (CW SROs) has been limited in the past mainly because of the high threshold powers necessary. Thresholds of SROs are orders of magnitude greater than doubly resonant oscillators. While lithium niobate has long been in use as a nonlinear material, periodically poled lithium niobate (PPLN) recently emerged as an excellent source for CW SROs. Quasi-phase matching with PPLN has allowed access to the higher nonlinear coefficients of lithium niobate permitting construction of CW SROs. By placing the OPO within the laser resonator, threshold should be significantly reduced. We have designed, built, and investigated an optical parametric oscillator within a laser cavity to access the high circulating fields within the resonator. The intracavity OPO acted as the output coupler for the laser and ideally the total down converted power from the OPO should approach the maximum output power available from th pump laser under optimal output coupling. PPLN OPOs were built within the resonators of a lamp-pumped Nd:YAG laser and a diode-pumped Nd:YVO4 laser. Combined idler output at 3.3 microns from both ends of an intracavity 30-mm PPLN OPO was 1.15 W. Output of the Nd:YVO4 laser optimized for 1.064-micron output with the same resonator was 5 W. The entire device, except for power supply and cooler, fit on a 1' x 2' breadboard.
Continuous Wave Singly Resonant Intracavity Optical Parametric Oscillators Using Periodically Poled LiNbO3
Author: Leonel Pastor Gonzalez
Publisher:
ISBN:
Category : Continuous wave radar
Languages : en
Pages : 216
Book Description
The use of continuous wave singly resonant optical parametric oscillators (CW SROs) has been limited in the past mainly because of the high threshold powers necessary. Thresholds of SROs are orders of magnitude greater than doubly resonant oscillators. While lithium niobate has long been in use as a nonlinear material, periodically poled lithium niobate (PPLN) recently emerged as an excellent source for CW SROs. Quasi-phase matching with PPLN has allowed access to the higher nonlinear coefficients of lithium niobate permitting construction of CW SROs. By placing the OPO within the laser resonator, threshold should be significantly reduced. We have designed, built, and investigated an optical parametric oscillator within a laser cavity to access the high circulating fields within the resonator. The intracavity OPO acted as the output coupler for the laser and ideally the total down converted power from the OPO should approach the maximum output power available from th pump laser under optimal output coupling. PPLN OPOs were built within the resonators of a lamp-pumped Nd:YAG laser and a diode-pumped Nd:YVO4 laser. Combined idler output at 3.3 microns from both ends of an intracavity 30-mm PPLN OPO was 1.15 W. Output of the Nd:YVO4 laser optimized for 1.064-micron output with the same resonator was 5 W. The entire device, except for power supply and cooler, fit on a 1' x 2' breadboard.
Publisher:
ISBN:
Category : Continuous wave radar
Languages : en
Pages : 216
Book Description
The use of continuous wave singly resonant optical parametric oscillators (CW SROs) has been limited in the past mainly because of the high threshold powers necessary. Thresholds of SROs are orders of magnitude greater than doubly resonant oscillators. While lithium niobate has long been in use as a nonlinear material, periodically poled lithium niobate (PPLN) recently emerged as an excellent source for CW SROs. Quasi-phase matching with PPLN has allowed access to the higher nonlinear coefficients of lithium niobate permitting construction of CW SROs. By placing the OPO within the laser resonator, threshold should be significantly reduced. We have designed, built, and investigated an optical parametric oscillator within a laser cavity to access the high circulating fields within the resonator. The intracavity OPO acted as the output coupler for the laser and ideally the total down converted power from the OPO should approach the maximum output power available from th pump laser under optimal output coupling. PPLN OPOs were built within the resonators of a lamp-pumped Nd:YAG laser and a diode-pumped Nd:YVO4 laser. Combined idler output at 3.3 microns from both ends of an intracavity 30-mm PPLN OPO was 1.15 W. Output of the Nd:YVO4 laser optimized for 1.064-micron output with the same resonator was 5 W. The entire device, except for power supply and cooler, fit on a 1' x 2' breadboard.
A Continuous Wave, Single Frequency Intracavity Optical Parametric Oscillator Based Upon the Twisted-mode Technique
Author: Lea Christina Heering
Publisher:
ISBN:
Category : Lasers
Languages : en
Pages : 132
Book Description
Publisher:
ISBN:
Category : Lasers
Languages : en
Pages : 132
Book Description
Tunable, Continuous-wave Single-resonant Optical Parametric Oscillator with Output Coupling for Resonant Wave*Project Supported by the National Natural Science Foundation of China (Grant Nos. 61308056, 11204044, 11232015, and 11072271), the Research Fund for the Doctoral Program of Higher Education of China (Grant Nos. 20120171110005 and 20130171130003), the Fundamental Research Funds for the Central Universities of China (Grant No. 14lgpy07), and the Opening Project of Science and Technology on Reliability Physics and Application Technology of Electronic Component Laboratory, China (Grant No. ZHD201203).
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :
Book Description
Abstract: We present a continuous-wave singly-resonant optical parametric oscillator with 1.5% output coupling of the resonant signal wave, based on an angle-polished MgO-doped periodically poled lithium niobate (MgO:PPLN), pumped by a commercial Nd:YVO4 laser at 1064 nm. The output-coupled optical parametric oscillator delivers a maximum total output power of 4.19 W with 42.8% extraction efficiency, across a tuning range of 1717 nm in the near- and mid-infrared region. This indicates improvements of 1.87 W in output power, 19.1% in extraction efficiency and 213 nm in tuning range extension in comparison with the optical parametric oscillator with no output coupling, while at the expense of increasing the oscillation threshold by a factor of ∼ 2. Moreover, it is confirmed that the finite output coupling also contributes to the reduction of the thermal effects in crystal.
Publisher:
ISBN:
Category :
Languages : en
Pages :
Book Description
Abstract: We present a continuous-wave singly-resonant optical parametric oscillator with 1.5% output coupling of the resonant signal wave, based on an angle-polished MgO-doped periodically poled lithium niobate (MgO:PPLN), pumped by a commercial Nd:YVO4 laser at 1064 nm. The output-coupled optical parametric oscillator delivers a maximum total output power of 4.19 W with 42.8% extraction efficiency, across a tuning range of 1717 nm in the near- and mid-infrared region. This indicates improvements of 1.87 W in output power, 19.1% in extraction efficiency and 213 nm in tuning range extension in comparison with the optical parametric oscillator with no output coupling, while at the expense of increasing the oscillation threshold by a factor of ∼ 2. Moreover, it is confirmed that the finite output coupling also contributes to the reduction of the thermal effects in crystal.
Continuous-Wave 4.3-mu Intracavity Difference Frequency Generation in an Optical Parametric Oscillator
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 6
Book Description
We have achieved 150 mW of cw output at 4.3 micrometers, using difference frequency mixing in a singly resonant optical parametric oscillator (OPO). We pumped the OPO cavity, which contains periodically poled LiNbO3 (PPLN), with a 14-W 1.06-micrometers Nd:YAG laser to generate a signal at 1.7 micrometers and an idler at 2.8 micrometers. Mixing of the two waves at the same crystal temperature and grating spacing yielded emission in the mid IR. This technique avoids the mid-IR absorption-high-threshold problem, which has limited the cw performance of PPLN OPOs at wavelengths beyond 4 micrometers. Provided that tunability is not required, this method is a simple alternative to multiple-crystal configurations.
Publisher:
ISBN:
Category :
Languages : en
Pages : 6
Book Description
We have achieved 150 mW of cw output at 4.3 micrometers, using difference frequency mixing in a singly resonant optical parametric oscillator (OPO). We pumped the OPO cavity, which contains periodically poled LiNbO3 (PPLN), with a 14-W 1.06-micrometers Nd:YAG laser to generate a signal at 1.7 micrometers and an idler at 2.8 micrometers. Mixing of the two waves at the same crystal temperature and grating spacing yielded emission in the mid IR. This technique avoids the mid-IR absorption-high-threshold problem, which has limited the cw performance of PPLN OPOs at wavelengths beyond 4 micrometers. Provided that tunability is not required, this method is a simple alternative to multiple-crystal configurations.
Continuous Wave Singly Resonant Optical Parametric Oscillator
Author: Steven Tsung-Lin Yang
Publisher:
ISBN:
Category :
Languages : en
Pages : 276
Book Description
Publisher:
ISBN:
Category :
Languages : en
Pages : 276
Book Description
Continuous Wave Diode-pumped Doubly-resonant Optical Parametric Oscillator
Author: Carrie Sjaarda Cornish
Publisher:
ISBN:
Category : Lasers
Languages : en
Pages : 158
Book Description
Publisher:
ISBN:
Category : Lasers
Languages : en
Pages : 158
Book Description
Continuous-wave, Intracavity Optical Parametric Oscillators
Author: Graham Alexander Turnbull
Publisher:
ISBN:
Category :
Languages : en
Pages : 172
Book Description
Publisher:
ISBN:
Category :
Languages : en
Pages : 172
Book Description
Optical Parametric Oscillators
Author: Stanford University. Microwave Laboratory
Publisher:
ISBN:
Category :
Languages : en
Pages : 114
Book Description
Publisher:
ISBN:
Category :
Languages : en
Pages : 114
Book Description