An Experimental Investigation Into the Flow Through a Centrifugal Compressor PDF Download

Author: Faris Fakhri ABDUL-KADIR
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

View

Book Description

Author: Robert Paul STAM
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

View

Book Description

Author: Uwe Zachau
Publisher:
ISBN: 9783832268312
Category : Compressors
Languages : en
Pages : 226

View

Book Description

Author: N. Kammer
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

View

Book Description

Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781721640812
Category :
Languages : en
Pages : 32

View

Book Description
Results from a series of experiments to investigate techniques for extending the stable flow range of a centrifugal compressor are reported. The research was conducted in a high-speed centrifugal compressor at the NASA Glenn Research Center. The stabilizing effect of steadily flowing air-streams injected into the vaneless region of a vane-island diffuser through the shroud surface is described. Parametric variations of injection angle, injection flow rate, number of injectors, injector spacing, and injection versus bleed were investigated for a range of impeller speeds and tip clearances. Both the compressor discharge and an external source were used for the injection air supply. The stabilizing effect of flow obstructions created by tubes that were inserted into the diffuser vaneless space through the shroud was also investigated. Tube immersion into the vaneless space was varied in the flow obstruction experiments. Results from testing done at impeller design speed and tip clearance are presented. Surge margin improved by 1.7 points using injection air that was supplied from within the compressor. Externally supplied injection air was used to return the compressor to stable operation after being throttled into surge. The tubes, which were capped to prevent mass flux, provided 9.3 points of additional surge margin over the baseline surge margin of 11.7 points. Skoch, Gary J. Glenn Research Center NASA/TM-2003-212599, E-14156, ARL-TR-2921, GT-2003-38524

Author: Gregory Brenton Shirley
Publisher:
ISBN:
Category :
Languages : en
Pages : 120

View

Book Description

Author: Gary J. Skoch
Publisher: BiblioGov
ISBN: 9781289260743
Category :
Languages : en
Pages : 28

View

Book Description
Results from a series of experiments to investigate whether centrifugal compressor stability could be improved by injecting air through the diffuser hub surface are reported. The research was conducted in a 4:1 pressure ratio centrifugal compressor configured with a vane-island diffuser. Injector nozzles were located just upstream of the leading edge of the diffuser vanes. Nozzle orientations were set to produce injected streams angled at 8, 0 and +8 degrees relative to the vane mean camber line. Several injection flow rates were tested using both an external air supply and recirculation from the diffuser exit. Compressor flow range did not improve at any injection flow rate that was tested. Compressor flow range did improve slightly at zero injection due to the flow resistance created by injector openings on the hub surface. Leading edge loading and semi-vaneless space diffusion showed trends similar to those reported earlier from shroud surface experiments that did improve compressor flow range. Opposite trends are seen for hub injection cases where compressor flow range decreased. The hub injection data further explain the range improvement provided by shroud-side injection and suggest that different hub-side techniques may produce range improvement in centrifugal compressors.

Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781721676873
Category :
Languages : en
Pages : 24

View

Book Description
Results from a series of experiments to investigate whether centrifugal compressor stability could be improved by injecting air through the diffuser hub surface are reported. The research was conducted in a 4:1 pressure ratio centrifugal compressor configured with a vane-island diffuser. Injector nozzles were located just upstream of the leading edge of the diffuser vanes. Nozzle orientations were set to produce injected streams angled at 8, 0 and +8 degrees relative to the vane mean camber line. Several injection flow rates were tested using both an external air supply and recirculation from the diffuser exit. Compressor flow range did not improve at any injection flow rate that was tested. Compressor flow range did improve slightly at zero injection due to the flow resistance created by injector openings on the hub surface. Leading edge loading and semi-vaneless space diffusion showed trends similar to those reported earlier from shroud surface experiments that did improve compressor flow range. Opposite trends are seen for hub injection cases where compressor flow range decreased. The hub injection data further explain the range improvement provided by shroud-side injection and suggest that different hub-side techniques may produce range improvement in centrifugal compressors. Skoch, Gary J. Glenn Research Center NASA/TM-2004-213182, ARL-TR-3158, GT2004-53618, E-14677

Author: Roland Sovrano
Publisher:
ISBN:
Category :
Languages : en
Pages :

View

Book Description

Author: Friedrich Justen
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

View

Book Description
Presented at the International Gas Turbine & Aeroengine Congress & Exhibition, Stockholm, Sweden, Jun 2-5, 1998.